User's Manual

SAFARI
TM
System User Guide
2
Powering Up the Primary Handset
The Primary Handset is automatically powered up once it is connected to the dedicated
HANDSET port. Depending on the conditions of the UE, the Primary Handset may start in
the following modes:
Full functioning mode
Primary Handset starts in this mode once it has successfully connected to the UE and there
is no PIN authentication required. All UE settings including contacts, messages and call logs
are loaded into local memory of the Primary Handset once the UE is configured. You will be
able to access all the menus and making voice or data calls once the Primary Handset is
ready.
PIN mode
Primary Handset starts in this mode once it has successfully connected to the UE and PIN
authentication is required. Depending on the enabled PIN, you are required to enter the
correct PIN/password before proceeding to Full functioning mode. Refer to Security
settings menu for more information on the types of security PIN in the UE.
To enter the PIN:
1. Key in the PIN of the security key using the alpha-numeric keypad.
2. Press
key to confirm.
To cancel PIN entering:
1. Press the Right selection key
2. Confirm to start in Emergency only mode by pressing the
key.
Emergency only mode
Primary Handset starts in this mode once it has successfully connected to the UE and PIN
entering is bypassed (i.e. when you have forgotten the required PIN). You can only make
emergency calls or access local Phone manager menu in this mode.