Installation guide

PassFinder AP2620 VoIP Gateway , Release 1.00
AddPac Technology Proprietary & Documentation 47 - 46
[UTP cable (RJ-45 to RJ-45) Pinout]
In order to connect the gateway with other equipments (i.e. HUB), the RJ-
45 to RJ-45 Ethernet Cable is used. The RJ-45 Connector Pin sequence
is provided below and the transferred signal and Pinout specifications are
enlisted at the below table.
[ Figure 5-1 100Base-TX RJ-45 Connector ]
<Table 5-2> Signal and Pinout of Direct Ethernet Cable
RJ-45 Signal Direction RJ-45 Pin
1
Tx + →
1
2
Tx - →
2
3
Rx + ←
3
4
- -
4
5
- -
5
6
Rx - ←
6
7
- -
7
8
- -
8
1. These specifications are for serial cables connecting the gateway and
the HUB.
2. For gateway to gateway or gateway to PC connection, the Cross Cable
must be used.