Installation guide

PassFinder AP2620 VoIP Gateway , Release 1.00
AddPac Technology Proprietary & Documentation 47 - 38
Chapter 4. Power Supply and Check
Operational Status
AP2620 Gateway Booting and Operation
When power is supplied, the system is booted as described below.
z VoiceFinder AP2620 Gateway performs a self-test and checks basic
operations of the CPU, the memory and interfaces.
z The boot loader is executed, and the boot loader seeks for proper
software image files. The boot loader loads the broadcasting system
software from the flash memory.
z If the boot loader cannot find proper software image file from the flash
memory, the boot loader stands by in the boot mode until it receives
proper software from the remote system. (At this time, the boot
loader can download software through TFTP or FTP protocol.)
z When the software is loaded, the broadcasting system starts to operate
according to configuration information. However, if there is no
configuration information, it operates according to the default values,
and in this case, the operator shall set up related items for normal
operation of the network.
After connecting all the interfaces, supply the power to VoiceFinder AP2620
Gateway. Supply the power after connecting the adapter to VoiceFinder
AP2620 Gateway. Do not connect the adapter to the power supply before
connecting it to the gateway. Also, use 110V adapter in case the power
supply is 110V. However, the gateway detects both 110V and 220V, so
there is no additional setting required.