User`s guide

VoiceFinder AP2120 VoIP Gateway User’s Guide Version 1.00
AddPac Technology Co., Ltd. -
81 -
[Procedures]
Order Operation
1 Go to the configuration mode.
2 Enable the static Gateway process.
3
Set the source address and the static route for the destination
network.
4
Use “show” command and check if the route is correctly set in
the routing table.
5
With “Ping” command, check if the route can reach the
network.
1. The next-hop address of the static route should be the address directly
connected with the desired Gateway.
2. The default route is one of static routes, and the setting is same as that of the
static route. However, the destination address shall be zero subnet (0.0.0.0
address and 0.0.0.0 mask) in the zero network, and the next-hop address
shall be same with that of the static route.
[Related Commands and Syntax]
z router { static/rip/ospf }
Enables or disables a certain routing process.
z route <destination-IP-network> <address-mask> { <next-hop-address> /
ethernet / Ethernet / null } [ ( 0/1)/<null_int_#> ] [sub_int_#]
1. Designates the route to send the packet to the destination address
2. When using Candidate Default (default route,) both of the destination
address and the mask filed shall be zero.
3. The Gateway should be able to recognize the “next-hop-address”
Caution