User`s guide

VoiceFinder AP2120 VoIP Gateway User’s Guide Version 1.00
AddPac Technology Co., Ltd. -
65 -
4.4. Ethernet Configuration
4.4.1. Ethernet basic configuration
The Ethernet port of VoiceFinderAP2120 Gateway basically supports RJ-45.
However, if the connection device of the other side supports only the AUI port,
10 Base-T Medial Attach Unit (MAU) shall be used in the other side. The
Ethernet of VoiceFinderAP2120 Gateway uses the standard ARPA
encapsulation method as default. However, if necessary, the network
manager can use SNAP or IEEE 802.3 encapsulation method.
The Ethernet of VoiceFinderAP2120 Gateway can be separated logically. If
the user wishes to use only one Ethernet port, the user must designate the
logical port.
Follow as shown below to use Ethernet.
[Procedure]
Order Operation
1 Enter into the interface configuration mode.
2 Enter into the IP configuration mode.
3 Assign IP address to the interface.
4 Designate the encapsulation method to use (if necessary.)
5 Make the interface up.
6 Set other necessary optional parameters.
[Related Commands and Syntax]
z Ethernet full-duplex
1. Sets the operation mode of the Ethernet interface.
2. The default is half-duplex.