User`s guide

VoiceFinder AP2120 VoIP Gateway User’s Guide Version 1.00
AddPac Technology Co., Ltd. -
194 -
following setting.
Step Command Description
1 Router# configure
Enters into the global configuration
mode.
2 Router(config)# voice-port location
Enters into the designated voice port
configuration mode.
The location is indicated by the
slot-number/port-number.
3 Router(voice-port)# translate-incoming
{called-number | calling-number}
tag
called-number: Applies the
translation rule to the inbound called
party number.
calling-number: Applies the
translation rule to the inbound calling
party number.
The tag refers to the rule set and tag
values range from 0 to 65535.
If the translation rule is applied to the called party and if numbers are entered
into the voice port in order, check if translation is made for each number
entered. At this time, translation shall be made only once.
5.3.7.3. Applying Translation Rules to the Inbound VoIP Calls
To apply the translation rule set to all calls received from the network, make
following setting.
Step Command Description
1 Router# configure
Enters into the global configuration
mode.
2 Router(config)# voice service VoIP
Enters into the voice service VoIP
setup mode.
3 Router(vservice-VoIP)#
translate-VoIP-incoming {called-number |
calling-number}
tag
called-number: Applies the
translation rule to the inbound called
party.
calling-number: Applies the
translation rule to the inbound calling
party number.
The tag refers to the rule set and tag
values range from 0 to 65535.
5.3.7.4. Applying Translation Rules to the Outbound Calls
To apply the translation rule set to the outbound calls going to a certain dial