User`s guide

VoiceFinder AP2120 VoIP Gateway User’s Guide Version 1.00
AddPac Technology Co., Ltd. -
148 -
4.13. Fault Management and Debugging
This chapter describes how to handle and process faults while operating
VoiceFinder AP2120 Gateway. The AP2120 Gateway provides “show”,
“Debug” and “logging” commands for fault handling.
4.13.1. Logging Command
Logging command logs equipment operation status to manage equipments,
and decide the level of log information. Logging commands also can send
log information to a certain host outside. Logging configuration can be made
in the global configuration mode.
Logging configuration related commands are as follows:
z logging on
Enable logging for all available destinations.
z logging condition {option}
1. Set logging targets.
2. Option
1) command : Log commands used.
2) event interface {ethernet/Ethernet} [interface-number] : Log changes
of a certain interface.
3) event protocol {all/critical/icmp} : Log events of certain protocol.
4) alarm {all/critical/information/major/minor/warning} : Set logging
targets for alarms of certain level.
5) debugging : Log debugging information.
z logging destination {option}
1. Set conditions of the destination host to send logging information.
2. Option
1) ip <destnation-ip-address> : Set IP address of the remote host to send