User`s guide

VoiceFinder AP200 VoIP Residential Gateway (RGW) User’s Guide Version 1.1
AddPac Technology Co.,Ltd. -
50 -
available commands for the corresponding mode and descriptions of
commands.
z The VoiceFinder AP200 Gateway provides “History” function. With the
history function, the operator does not need to enter the command that
the operator had used before. Instead, the operator only needs to use
the numbers on the Gateway prompt.
z There are three modes for the Gateway commands, and in each mode,
different commands are used. The following describes commands that
can be used in each mode.
The commands indicated with “*” among the optional commands are not
currently supported. They are to be supported in the higher version Gateways.
Ex) router# clear ?
z counters Clear counters on one or all interfaces
z *interface Clear the hardware logic on an interface
z logging Clear logging buffer
z utilization Clear system usage information
To cancel commands, use “no” command. If the operator uses “no”
command for the commands that have default values, the optional values that
had been set before will return to default values.
Ex) router(config)# no ?
access-list : Add an access list entry
arp : Remove a static ARP entry
bridge : Set bridge Parameter to default value
dhcp-list : Configure list entry
ethernet : Configure Ethernet
hostname : Set system's network name
interface : Select an interface to configure
Caution
Caution