User`s guide

VoiceFinder AP200 VoIP Residential Gateway (RGW) User’s Guide Version 1.1
AddPac Technology Co.,Ltd. -
24 -
Rear View of AP200
In Rear Side of AP200 VoIP Residential Gateway, this equipment provides the
two 10Mbps Ethernet interfaces, RS-232C serial port for management, and FXS,
FXO interface ports for voice signal processing. Two Ethernet ports are used for
WAN side and LAN Side Ethernet interface each. Using two Ethernet ports,
AP200 supports the various WAN-to-LAN Routing Service and QoS services.
AP200-A Type Model
Figure 1-5 shows the “Type A” Interface configuration of AP200 VoIP Residential
Gateway. (AP200 Model A)
[Figure 1-5 Back Side Panel Diagram of VoiceFinder AP200 Model A VoIP RGW]
Following Table 1-2 explains the “Type A” interface of AP200 VoIP Residential
Gateway.
[Table 1-2 The explanation of Back Side Panel Interfaces of AP200 Model A
RGW]
Power PSTN FXS0 FXS1 LAN0 LAN1 CONSOLE
No. Interface Explanation
(1)
DC Power
External DC Power Supply Input. (DC 5V)
(2)
PSTN
This port is used to connect PSTN Analog Line
for PSTN backup. (RJ11)
(3)
FXS 0
1 FXS Port : As FXS Voice Interface Port, Phone
or Fax Machine can be connected.(1x RJ11)
(4)
LAN0
10Mbps Ethernet Port for WAN interface (RJ45)
(5)
LAN1
10Mbps Ethernet Port for LAN interface. In case
of AP200 Model A Model, 4-Port HUB Interface
is provided (RJ45)
(6)
Console
RS-232C serial port for system management
(RJ45)