User`s guide

VoiceFinder AP200 VoIP Residential Gateway (RGW) User’s Guide Version 1.1
AddPac Technology Co.,Ltd. -
104 -
[Related Commands and Syntax]
z bridge
As an interface command, sets that the corresponding interface should
function as a bridge group.
z frame-relay map bridge <dlci-number>
1. An interface command. If the interface using the bridge is frame-relay,
this command sets the map in a way that the bridge maps can be sent
through this interface.
2. DLCI values is any number between 16 and 1007.
3. If a bridge is used in the frame-relay interface, the user must use “MAP”
command to enable the bridge.
z bridge priority <priority-number>
1. An option of the interface command. This command defines the
priority of the interface to be blocked or forwarded while participating
in the spanning tree procedure.
2. The range is between 0 and 255. The lower the number is, the higher
the priority is. The default is 0.
z bridge path-cost <path-cost-value>
1. An option of the interface command. This command defines the
priority of the interface to be blocked or forwarded while participating
in the spanning tree procedure.
2. The range is between 0 and 65535. The lower the number is, the higher
the priority is. The default is 100 for Ethernet or 128 for Serial.
z bridge hello-time <hello-interval>
1. An optional command of “Global” command. This command defines
Hello Interval between BPDUs.
2. The range is between 1 ~ 10 seconds. The default value is two
seconds.