User`s guide

VoiceFinder AP1100 VoIP Gateway User’s Guide Version 1.1
AddPac Technology Co., Ltd. -
72 -
unregistered IP addresses into a protocol port number on an external,
registered IP address.
1. The VoiceFinder AP1100 Gateway currently supports only dynamic address
translation.
2. The VoiceFinder AP1100 Gateway supports 256 NAT addresses.
3. The VoiceFinder AP1100 Gateway only static routing for NAT.
[Procedure]
Order Operation
1 Move to the configuration mode.
2
Create the NAT/PAT-list defining the official address to use.
9 At this time, decide where to use the global address – inside or
outside.
9 Define and set the entry to statistically match address
translation between the inside address and the outside
address.
9 The user needs to set timeout value of the session and
recovery of the allocated address for the idle status when no
data is transmitted through NAT.
3 Go to the interface configuration mode.
4 Enter into the IP configuration mode.
5
Apply the NAT/PAT-List that has been set to the corresponding
interface.
6
Use “Show nat-list” command to check if correct access-list has
been set.
[Related Commands and Syntax]
z nat <nat-list-number> nat outside-global <start-address> <end-address>
<mask>
1. Creates NAT pool for the outside global address in the global