User`s guide

VoiceFinder AP1100 VoIP Gateway User’s Guide Version 1.1
AddPac Technology Co., Ltd. -
23 -
3.1. Installation
3.1.1. Installation Procedure
z Plug in the console cable and configure the console terminal. (Refer to
3.1.2 for details.)
z Connect the network to the desired port. Use RJ-45 cable with the LAN 1
port for connection with ADSL/Cable Modem or Router, and the RJ-45
cable with the LAN 0 port for connection with the HUB/Switch.
z Log in the Gateway after the booting message on the console with the
root account. (Configuration is only possible when logged in with the root
account.)
z Switch to Configuration Mode.
z Assign an internet address to the desired port of usage. (Refer to Interface
Configuration.)
z Configure the settings for the routing and VoIP related. (Refer to Chapter 4
and 5.)
z Confirm the configured settings. (Refer to the Gateway administrative
commands.)
z Save the settings on Flash Memory. (VoiceFinder AP1100 immediately
operates under the new settings, but under certain network environments
rebooting is required.) (Refer to the following instructions for this part.)
z Using commands such as Ping, Telnet, rlogin etc. check the status of other
Gateways or PCs connected to the Gateway.
Caution