User`s guide

VoiceFinder AP1100 VoIP Gateway User’s Guide Version 1.1
AddPac Technology Co., Ltd. -
155 -
5.4. Configuration Voice Ports
5.4.1. Configuration Voice Ports on the AP1100 Gateway
In general, voice port commands define the characteristics associated with a
particular voice port signaling type. Under most circumstances, the default
voice port command values are adequate to configure FXO and FXS ports to
transport voice data over your existing IP network.
5.4.2. Voice Ports Configuration Task List and Steps
5.4.2.1. Configuring FXS or FXO Voice Ports
Under most circumstances the default voice port values are adequate for both
FXO and FXS voice ports. If you need to change the default configuration for
these voice ports, perform the following tasks. The first two tasks are required;
the third task is optional.
1) Identify the voice port and enter the voice-port configuration mode.
2) Configure the following mandatory voice-port parameters.
3) Configure one or more of the following optional voice-port parameters.
¾ PLAR(Private Line Auto Ringdown) 연결 모드
¾ Description
¾ Ring Number
¾ Input Gain
¾ Output Gain
Step Command Description
1 configure
Enter global configuration mode.
2 voice-port location
Identify the voice port you want to configure and
enter voice-port configuration mode.
3 ring number number
(For FXO ports only) Specify the maximum number of
rings to be detected before answering a call.
4 connection plar string
(Optional) Specify the private line auto ringdown