User`s guide

VoiceFinder AP1100 VoIP Gateway User’s Guide Version 1.1
AddPac Technology Co., Ltd. -
136 -
5.3.2.3. VoIP Peer Configuration
Set the VoIP peer as follows:
z Decide the dial peer tag value.
z Decide the destination pattern.
z Decide the session target.
In most of the cases, other values than these shall be default values.
Step Command Description
1 Router# configure
Enters into the configuration mode.
2 Router(config)# dial-peer voice
tag
VoIP
Enters into the VoIP configuration
mode of the dial-peer
configuration.
The tag is the only identifier of the
dial-peer of this system, and tag
values range from 0 to 65535.
The VoIP means communication
service configuration of the VoIP
peer.
3 Router(config-dial-peer)# destination-pattern
string
[T]
Enters the telephone number of the
corresponding dial peer.
The string means the telephone
number, and string values include 0
~ 9, (#), (*) and wildcard (.).
The period (.) means the wildcard.
Users can selectively enter (T) after
the telephone number, and if a
user enters (T) the system will
collect dial digits till the
end-of-dialing key (default #) or till
the inter-digit timer finishes.
4 Router(config-dial-peer)# session target
destination-ip-address
Enters the IP address of the
corresponding VoIP peer.
The destination-ip-address shall be
entered as a dotted decimal IP
address. (Example: 123.321.1.2)
If the destination-ip-address is “ras”
the IP address of the corresponding
VoIP peer will be found through the
gatekeeper.
5 Router(config-dial-peer)# dtmf-relay
[h245-alphanumeric]
(Selectively used.)
Decides the DTMF tone transmission
method for the corresponding
VoIP-peer.
The default value is
h245-alphanumeric.