Specifications

VoiceFinder VoIP Gateway Configuration Guide (APOS 2.0) Release Version 3.1
AddPac Technology Co., LTD
- 91 / 416-
2.11. Configuring PPPoE + Bridge
PPPoE + Bridge function enables another network equipment to use a bridge function to access
another PPPoE Session through xDSL modem when Multi-PPPoE is supported from one xDSL
modem.
Figure 2.3 VoIP Network Diagram for PPPoE + Bridge Environment
Relaying packets transparently is similar to the bridge mode configuration.
PPPoE + Bridge mode takes only PPPoE Session, connected to VoIP gateway, of its own among
the packets, which arrive on the determined destination on the network side interface and
delivers the rest of the packets transparently.
Configuring QoS is possible by using APOS commands for voice traffic priority order control
on LAN0 Ethernet 0.0 interface of the gateway accessing towards IP network. Such QoS
configuration for all the incoming data and voice data to LAN1 Ethernet1.0 VoIP gateway
supports maintaining the maximum voice quality through QoS provision for priority order and
bandwidth control.
[Usage Procedure]
Steps Workflow Description
1 Change to configuration mode
2 Configure PPPoE on WAN Interface
3 Configure bridge on WAN and LAN interfaces.
4 Disable ip routing