Specifications

VoiceFinder VoIP Gateway Configuration Guide (APOS 2.0) Release Version 3.1
AddPac Technology Co., LTD
- 81 / 416-
2.9. Configuring Transparent Bridging
VoiceFinder Gateway supports Transparent Bridging for Ethernet and Serial ports. Also it
supports Bridge MIB based on RFC1286 standard for network management.
The followings are the bridge functions that VoiceFinder Gateway supports.
z The bridge functions comply with IEEE802.1 standard.
z The functions can segment Transparent Bridged Network to the logical VLAN
z The functions can support through not only FastEthernet, but also Serial, Frame relay
networks.
z It supports the standard Spanning-Tree Algorithm by using BPDU(Bridged Protocol Data
Unit) of IEEE standard (applied to some product models)
VoiceFinder Gateway Series support 1 Bridge-Group in general. Therefore, the concept of
Bridge-Group is not used but the same id (generally 1). However, in case of supporting
VLAN, many logical interfaces can be provided for the one physical interface, so more
than 2 Bridge-Group can be supported.
[Usage Procedure]
Steps Workflow Description
1 Move to configuration mode
2 Specify a value of option to be used in Bridge
3 Move to interface configuration mode
4 Apply configured Bridge-Group to the interface
5 Map Multi-Access interface such as Frame Relay
6 Apply Bridging Option parameters for other uses
7
Use show bridge or show span commands to check whether bridge is
configured in a desired way and Spanning Tree Algorithm operates
correctly