Specifications

VoiceFinder VoIP Gateway Configuration Guide (APOS 2.0) Release Version 3.1
AddPac Technology Co., LTD
- 72 / 416-
suitable to VoIP equipment
1. The current version of VoiceFinder Gateway supports Dynamic Address Translation only.
2. The number of NAT addresses which are supported by VoiceFinder Gateway is 256.
3. The routing protocol related to NAT in the current version of VoiceFinder Gateway
supports Static Routing and RIP only.
[Usage Procedure]
Steps Workflow Description
1 Enter configuration mode
2
Create NAT/ PAT provisioned by the public IP address to be used.
9 At first, decide whether the Global Address to be used outside or
inside
9 Determine and configure a entry to be matched statically between
the Inside and outside Address
9 Configure Session Time-Out to return the allocated address to be
free, when NAT Session is in idle status
3 Move to interface configuration mode
4 Move to IP configuration mode
5 Apply the configured NAT/PAT to the interface
6
Use show running-config command to check whether NAT, access-list is
configured correctly.
[Related Commands and Format]
z ip nat <inside/pool/translation><pool name><Start IP address><End IP
address><netmask>
1. Configure nat pool to specify outside ip addresses when the inside packet communicates
with the outside
2. Pool Name can be assigned by user.
3. When to communicate with the outside, specify ip address range. The user using the