Specifications

VoiceFinder VoIP Gateway Configuration Guide (APOS 2.0) Release Version 3.1
AddPac Technology Co., LTD
- 52 / 416-
Specify a timeout value and periodic forwarding time in APOS G2 version
z shutdown / no shutdown
1. This is a command to up/down the presently located interface
2. There is no way to shut down the main Ethernet interface. To link up and down a
particular Ethernet interface, you can do it on the sub interface
z no interface <if-name>
This is a commad to delete a logical interface. The physical interface which is created from
the hardware equipment can not be eliminated (i.e. FastEthernet0/0, Loopback0 and others)
z show interface <if-name>
Show interface status of if-name
[Usage Example] Ethernet Configuration Example
model name(config)#interface FastEthernet 0/0 ☞ Logical
interface Ethernet 0.0 is created from Main interface Ethernet 0 and changes to the
configuration status for that interface.
model name(config-if)# ☞ At this mode, the interface can be configured.
model name(config-if)# ip address 131.12.1.1 255.255.0.0 ☞
Set IP address to 131.12.1.1/16bit mask
model name(config-if)#no shutdown ☞ When Main interface up, also
Sub-interface up automatically
model name(config-if)# end ☞Move to configuration mode
model name#show interface FastEthernet 0/0
Interface FastEthernet0/0
flags=8003<UP,BROADCAST,MULTICAST> index 2 metric 1 mtu
1500
mac address 0002.a4ff.fe7e
inet 131.12.1.1 255.255.0.0 broadcast 131.12.255.255
FastEthernet0/0 is DOWN, Line protocol is DOWN
QoS control is disabled
interface type is 100Base-TX
link status is 0 Mbps (HALF-DUPLEX)
0 packets input, 0 bytes, 0 no buffers