Specifications

VoiceFinder VoIP Gateway Configuration Guide (APOS 2.0) Release Version 3.1
AddPac Technology Co., LTD
- 50 / 416-
2.4. Configuring Ethernet
2.4.1. Basic Setups
Basically, VoiceFinder Gateway supports one or more RJ-45 ethernet ports. If the connecting
device supports only AUI port, it is necessary to use 10Base-T MAU (Media Attach Unit). The
ethernet port supports standard ARPA encapsulation, and it can be set to SNAP or IEEE802.3
Encapsulation.
More than one logical ports can be applied the physical ethernet port, and a logical port should
be exist to use it.
[Usage Procedure]
Step Workflow Description
1 Enter interface configuration mode
2 Assign an IP address to the interface
(For using IPv6, an IPv6 address needs to be assigned)
3 (Optional) Specify an Encapsulation to be used
4 Up the interface
5 Set up other optional parameters
[Related Commands and Formats]
z full-duplex/ half-duplex/ duplex {full| half| auto}
1. Set to operation mode of Ethernet Interface
2. The default value is set to Auto
z speed {10| 100| 1000| auto}
1. Set to speed of Ethernet Interface
2. The default value is set to Auto
3. Set to 1000 for supporting Gigabit