Specifications

VoiceFinder VoIP Gateway Configuration Guide (APOS 2.0) Release Version 3.1
AddPac Technology Co., LTD
- 39 / 416-
2.2.5. VoIP Configuration Commands
2.2.5.1. voice service voip Commands
In this mode, VoIP related global configuration can be configured. The
(config-vservice-voip)# prompt will be shown by typing “voice service voip” command
at global configuration mode.
Commands Description
accept-fse-at-connect
Accept only fast start element at CONNECT message.
This prevents early listen of inband ring back tone
announcement Enables a voice announcement of the voice-port
busyout Enable busyout monitoring
cdr Set syslog CDR (Call Deatail Record) format
counter Set counter values
default Set default values
delayed-connect Enable delayed connect on FXO
display Set display name option either H.323 id or E.164 address
dynamic-payload-type Set dynamic payload type
end Return to the beginning (exec)
exit Return to the previous mode
fax Set fax protocol and rate
force-h245address-at-
setup
Set H.245 address at H.323 SETUP message when
tunneling is disabled
force-starth245
Send startH245 message explicitly when H.323 tunneling
is disabled
h323
Set H.323 specific mode settings (i.e., fast start/slow start,
response message, H.245 tunneling mode, channel open
mode)
ignore-dtmf-abcd-tone Set ignoring ABCD DTMF tone
ignore-reverse-channel
-info Set ignoring reverse fast start element on ACK
inband-ringback-tone
Enable transmit inband ringback tone when receiving a
voip call