Specifications

VoiceFinder VoIP Gateway Configuration Guide (APOS 2.0) Release Version 3.1
AddPac Technology Co., LTD
- 36 / 416-
2.2.4. Network interface Configuration Commands
2.2.4.1. Ethernet interface Commands 1
Interface configuration mode assigns a particular interface for the settings of the configurations
mode. The gateway has 1 Ethernet interface for the uplink and another Ethernet interface for
the down link.
Commands Description
bandwidth Set the bandwidth informational parameter to kilobits
bridge-group Specify the bridge parameter.
cdp Enable CDP of the interface
description Describe the text in interface configuration mode
encapsulation
Configure the encapsulation for a designated interface
(supporting Ethernet, IEEE 802.1q VLAN, IEEE802.3
Encapsulation)
exit Return to the previous mode
end Return to the beginning mode
full-duplex Set Ethernet to full- duplex
half-duplex Set Ethernet to half-duplex
Interface Configure another interface
Ip To configure settings of IP service related and IP protocol.
ipv6 To set the settings of IPv6 service related and IP protocol
no
Cancel the command which has been entered or returns to the
default value.
mac-address Change a value of mac-address of a designated interface
multicast Configure a designated interface to multicast flag
multicast-all
Configure a designated interface to receive all the multicast
packets as a user’s command
ppp
Specify a value for accessing Point-to-Point Protocol in interface
configuration mode
peer Allocate the addresses while PPP is in operation
pppoe Specify a value for accessing PPP over Ethernet