Specifications

VoiceFinder VoIP Gateway Configuration Guide (APOS 2.0) Release Version 3.1
AddPac Technology Co., LTD
- 317 / 416-
3.10.5.17. sip-server
To configure a network address for the Session Initiation Protocol (SIP) server interface, use the
sip-server command in SIP UA configuration mode. To remove a network address configured
for SIP, use the no form of this command.
sip-server ip-addr [port] [priority
no sip-server ip-addr
3.10.5.17.1. Syntax
Keyword / Argument Description
IP-address Send SIP REGISTER Message to the specified address
Port Designates UDP port of SIP Proxy server optionally. The
default value is 5060.
Priority Specifies many alternate SIP proxy servers in a priority.
Ranges from 0~24, as the value becomes lower, higher the
precedence. The default is 128.
SIP Server ID Specifies IP of SIP server.
This is a simple description which does not affect any SIP
message field.
3.10.5.17.2. Command Default
No default behavior or value.
3.10.5.17.3. Command Modes
SIP-UA Configuration Mode
3.10.5.17.4. Usage Guidelines
SIP User Agent is registered SIP proxy server as RAS (Registration, Admission, and Status)
server and receives number and accounting services. AP1000 gateway is able to assign more
than one proxy server to the gateway. A list of proxy server can be displayed by show sip
command. When more than one proxy server is specified, registration is tries by using
REGISTER message to the proxy server in an order. Only one proxy server can be registered at
same time. If receiving message with the proxy server is failed, the gateway retries registration
to the proxy server in a priority order.
SIP Signaling port address based on SIP RFC 2543/3261 is 5060.