Specifications

VoiceFinder VoIP Gateway Configuration Guide (APOS 2.0) Release Version 3.1
AddPac Technology Co., LTD
- 28 / 416-
2.2. Command Instructions
This chapter describes how to configure VoiceFinder Gateways and explains the commands.
All the commands for configuring the gateways can be used by accessing Telnet or connecting
to console.
After the power is turned on, the gateways go through the following process:
z The gateways go through self-testing process then check their basic operation of CPU,
memory and interface.
z After the Boot Loader is performed, the gateways look for the software image file. At the
default configuration, the gateway is to load the software in the flash memory
z If the gateways can not find the software image file from the flash memory, the stand-by at
the boot mode until they can download the proper software (at this time, FTP or TFTP
protocol can be used to download the proper software for the gateways).
z The gateways operate basing on the setting information which is saved after the software is
downloaded.
The gateway command marked with the asterisk mark ‘*’ is not currently supported, but it will
be supported in the near future.
The commands that are related to IPv6 can be applied for the product which supports IPV6.
Some products can be applied with IPv6 in APOS 2.0 version.
If there is no corresponding command, the product does not support the function.
Example) (name of the product model)# clear ?
z arp-cache Clear the entire ARP cache
z cdp CDP information
z counters Clear counters on one or all interfaces