Specifications

VoiceFinder VoIP Gateway Configuration Guide (APOS 2.0) Release Version 3.1

AddPac Technology Co., LTD

- 273 / 416-

3.10.4.13. register

To configure a gateway to register or deregister a fully-qualified dial-peer E.164 address with a

gatekeeper, use the register e164 command in dial peer configuration mode. To deregister the

E.164 address, use the no form of this command.

no register e164

3.10.4.13.1. Syntax

Keyword / Argument Description

This command has no arguments or keywords.

3.10.4.13.2. Command Default

No default behavior or values

3.10.4.13.3. Command Modes

Dial peer configuration

3.10.4.13.4. Usage Guidelines

Use this command to register the E.164 address of an analog telephone line attached to a

foreign exchange station (FXS) port on a router. The gateway automatically registers fully

qualified E.164 addresses. Use the no register e164 command to deregister an address. Use the

Before you automatically or manually register an E.164 address with a gatekeeper, you must

create a dial peer (using the dial-peer command), assign an FXS port to the peer (using the port

command), and assign an E.164 address using the destination-pattern command. The E.164

address must be a fully qualified address. For example, +5551212, 55501212, and 4085550112

are fully qualified addresses; 408555.... is not. E.164 addresses are registered only for active

interfaces, which are those that are not shut down. If an FXS port or its interface is shut down,

the corresponding E.164 address is deregistered.