Specifications

VoiceFinder VoIP Gateway Configuration Guide (APOS 2.0) Release Version 3.1
AddPac Technology Co., LTD
- 25 / 416-
Chapter 2 . The Gateway Configuration and Its
Commands
This chapter describes how to configure VoiceFinder Gateways and explains the commands.
2.1. Booting the Gateway
This chapter describes how to configure VoiceFinder Gateways and explains the commands.
All the commands for configuring the gateways can be used by accessing Telnet or connecting
to console.
After the power is turned on, the gateways go through the following process:
z The gateways go through self-testing process then check their basic operation of CPU,
memory and interface.
z After the Boot Loader is performed, the gateways look for the software image file. At the
default configuration, the gateway is to load the software in the flash memory
z If the gateways can not find the software image file from the flash memory, the stand-by at
the boot mode until they can download the proper software (at this time, FTP or TFTP
protocol can be used to download the proper software for the gateways).
z The gateways operate basing on the setting information which is saved after the software is
downloaded.
When the system is booted for the first time, the gateways perform the settings and these
settings must be saves by the commands of ‘write’ or ‘copy running-config’.
After the booting is processed normally, you can see the following message:
Caution