Specifications

VoiceFinder VoIP Gateway Configuration Guide (APOS 2.0) Release Version 3.1
AddPac Technology Co., LTD
- 247 / 416-
3.10.3.18. ring number
To specify the number of rings for a specified Foreign Exchange Office (FXO) voice port, use
the ring number command in voice port configuration mode. To reset to the default, use the no
form of this
command.
ring number number
no ring number number
3.10.3.18.1. Syntax
Keyword / Argument Description
number Number of rings detected before answering the call. Range is
from 1 to 255. This feature is useful for VoIP devices and
ARS. The default is 1.
3.10.3.18.2. Command Default
1 ring
3.10.3.18.3. Command Modes
Voice-port configuration
3.10.3.18.4. Usage Guidelines
Use this command to set the maximum number of rings to be detected before answering a call
over an FXO voice port. Use the no form of this command to reset the default value, which is
one ring.
Normally, this command should be set to the default so that incoming calls are answered
quickly. If you have other equipment available on the line to answer incoming calls, you might
want to set the value higher to give the equipment sufficient time to respond. In that case, the
FXO interface would answer if the equipment online did not answer the incoming call in the
configured number of rings.
This command is not applicable to Foreign Exchange Station (FXS) or E&M interfaces because
they do not receive ringing on incoming calls.