Specifications

VoiceFinder VoIP Gateway Configuration Guide (APOS 2.0) Release Version 3.1
AddPac Technology Co., LTD
- 234 / 416-
3.10.3.9. did
To enable the direct inward dialing (DID) call treatment for an incoming called number, use the
direct-inward-dial command in dial peer configuration mode. To disable DID on the dial peer,
use the no form of this command.
did { normal | none | ntt-modem | ntt-pb }
3.10.3.9.1. Syntax
Keyword / Argument Description
normal
Sends the number after hook-off. DID was introduced from
the initial version
none
No DID.
ntt-modem
Japanese NTT specific treatment. Dials in a specific order by
using FSK
ntt-pb
Japanese NTT specific treatment. Dials in a specific order by
using PB (Push Button)
3.10.3.9.2. Command Default
Normal
3.10.3.9.3. Command Modes
Voice-port configuration mode
3.10.3.9.4. Usage Guidelines
Use the direct-inward-dial command to enable the DID call treatment for an incoming called
number. When this feature is enabled, the incoming call is treated as if the digits were received
from the DID trunk. The called number is used to select the outgoing dial peer. No dial tone is
presented to the caller. Use the no form of this command to disable DID on the dial peer. When
disabled, the called number is used to select the outgoing dial peer. The caller is prompted for a
called number via dial tone. This command is applicable only to plain old telephone service
(POTS) dial peers.