Specifications

VoiceFinder VoIP Gateway Configuration Guide (APOS 2.0) Release Version 3.1
AddPac Technology Co., LTD
- 231 / 416-
3.10.3.7. connection trunk
To specify a plar for a voice port, use the connection plar command in voice-port configuration
mode. To disable the selected connection mode, use the no form of this command.
connection { plar } string
no connection { plar }
3.10.3.7.1. Syntax
Keyword / Argument Description
plar Specifies a private line automatic ringdown (PLAR)
connection. PLAR is an
autodialing mechanism that permanently associates a voice
interface with afar-end voice interface, allowing call
completion to a specific telephone number or PBX without
dialing. When the calling telephone goes off-hook,
a predefined network dial peer is automatically matched,
which sets up a call to the destination telephone or PBX.
string Specifies the destination telephone number. Valid entries are
any series of
numbers that specify the E.164 telephone number.
3.10.3.7.2. Command Default
No connection mode is specified.
3.10.3.7.3. Command Modes
Voice-port configuration
3.10.3.7.4. Usage Guidelines
Use the connection command to specify a connection mode for a specific interface. For
example, use the connection plar command to specify a PLAR interface. The string you
configure for this command is used as the called number for all incoming calls over this
connection. The destination peer is determined by the called number.
3.10.3.7.5. Examples
The following example shows PLAR as the connection mode with a destination telephone number