Specifications

VoiceFinder VoIP Gateway Configuration Guide (APOS 2.0) Release Version 3.1
AddPac Technology Co., LTD
- 176 / 416-
Pinouts for T1/E1 Trunk and
Digital Voice Port (RJ-45) Pin
signal
1 RX (tip)
2 RX (ring)
3 -
4 TX (tip)
5 TX (ring)
6 -
7 -
8 -
3.5.2. Common Configuration
Below is the configuration which is commonly applied, does not matter with the signaling type
of ISDN PRI/ R2.
Step Commands Purpose of Usage
1 configure terminal
Enter global configuration mode
2 controller e1 location
Enter the specified controller configuration mode
Indicate location as slot-number/port-number
3 channel-group timeslots expr
(mandatory)
Configure the channels of E1 to be used.
At default, the channel is not configured; therefore, it
must be configured.
If E1 module is placed in slot 0, use the following
commands to configure all the channels (the
following settings are used for most of cases). The
signaling channel, the number 16 is ignored from the
channel group configuration and does not need to be
considered.
model name(config)# controller e1 0/0
model name(config-controller-e1-0/0)#
channel-group timeslots 1-31
If channel 1, 2, 3, 8, 20, 21 are used as an
exceptional case, use the following commands:
model name(config-controller-e1-0/0)#
channel-group timeslots 1-3,8,20,21