Specifications

VoiceFinder VoIP Gateway Configuration Guide (APOS 2.0) Release Version 3.1
AddPac Technology Co., LTD
- 173 / 416-
¾ Timing other then Timeout
Use the following commands for tuning E&M.
Deactivate/ Activate the port by using shutdown / no shutdown command after changing
the settings of the voice port by using voice-port command.
Step Commands Purpose of Usage
1 configure terminal
Enter global configuration mode
2 voice-port location
Enter a specified voice port configuration mode
Indicate location as slot-number/port-number
3 input gain value
Specify a gain value to be added to the input
interface, by decibel units
The range to be used is -18 ~ 9
4 output gain value
Specify a gain value to be added to the output
interface by decibel units
The range for use is -18 ~ 9
5 timing delay-duration
milliseconds
Specify delay signal duration for delay dialing
signaling
The range for use is 100~5000 msec.
6 timing delay-start
milliseconds
Specify a minimum delay time sending the outgoing
signal after the incoming seizure is detected.
The range for use is 20~2000 msec.
7 timing wink-duration
milliseconds
Specify maximum wink signal duration.
The value range for possible use is 50~3000 msec.
8 timing wink-wait milliseconds
Specify maximum win-wait duration for wink start
signal.
The value range for possible use is 100~5000 msec.
9 timing dialout-delay
milliseconds
Specify dial-out delay for cut-through or sending the
number to E&M
The value range for possible use is 100~5000 msec.
10 timing wait-wink milliseconds
Specify a maximum wait value for wink signal.
The value range for possible use is 100~5000 msec.
3.4.2.4. Configuring E1 Voice
All the settings, which can be applied to analog FXS port, can be also applied to all the
channels in E1.
The followings are the commands to be applied to only E1 voice port
Step Commands Purpose
1. configure terminal
Enter global configuration mode
2. voice-port location
Enter the specified voice configuration mode
Indicate location as slot-number/port-number