Specifications

VoiceFinder VoIP Gateway Configuration Guide (APOS 2.0) Release Version 3.1
AddPac Technology Co., LTD
- 152 / 416-
6 – random
7 - sequential
As next step, you may configure the explicit priority order by preference or huntstop which can
be configured to the dial peer. If huntstop is configured to a specific dial peer and the outbound
call of that dial peer fails, then terminate the call without hunting to other dial peer.
Step Commands Description
1
model name# configure terminal Get into configuration
2
model name(config)# dial-peer voice tag
{ pots | voip }
Move to dial-peer configuration
tag is the only identifier of dial-peer and it
take the rage of value 0~65535
3
model name(config-dial-peer)#
preference number
The range of the value is 0-9 and less the
value, higher the priority is.
4
model name(config-dial-peer)# huntstop Set up huntstop to the dial peer
3.3.4.2. Rerouting to PSTN
As it is explained previously, hunt group enables PSTN rerouting through FXO voice port when
the connection to VoIP network fails. The following Figure 3.6 exhibits PSTN rerouting.
Figure 3.6 PSTN Rerouting
To make this PSTN routing to happen, configure the dial peer as to follow:
dial-peer voice 101 voip
destination-pattern 472....
session target 192.168.100.1
IP Cloud
Source
Destination
PBX
Voice Port
(FXO)
PSTN
Fail to connect