Specifications
VoiceFinder VoIP Gateway Configuration Guide (APOS 2.0) Release Version 3.1
AddPac Technology Co., LTD
- 145 / 416-
z When more than one POTS peers are specified to the same voice port, the POTS
peer created first is to be chosen.
The followings are the procedure of selecting inbound VoIP peer:
z Select the VoIP peer with answer-address matching with calling party number of the
inbound call.
z When the above selection fails, select the VoIP peer with destination-pattern
matching with calling party number of the inbound call.
z When the above selection fails, select the VoIP peer configured with the same IP
address as the outgoing gateway
Selection of inbound dial peer should be done for proper call control at inbounding phase.
In other words, each parameter configured to POTS or VoIP peer is applied to the chosen dial
peers. When the inbound POTS peer could not be found, the call will not be processed since the
voice port has no POTS peer. In case of inbound VoIP peer, the call can be still processed even
the final section of inbound VoIP fails
3.3.2.2. Configuring POTS Peer
Configuration of POTS peer can be accomplished in the following procedure:
z Determine dial peer tag value
z Determine destination pattern
z Determine the port
In most of cases, the values other than these are set to a default value.
Steps Commands Description
1
model name# configure terminal Get into configuration mode.
2
model name(config)# dial-peer voice tag
pots
Move to POTS configuration mode in
dial-peer.
‘tag’ in this system is the only identifier and
get the value of 0~65535.
‘pots’ represents configuration for the
communication service of FXS, FXO port
3
destination
string
[T]
Enter a relevant telephone number of dial
peer.
‘string’ means the telephone number 0~9,
(#), (*) value and wildcard (.) is possible,
Period ‘.’ represents wildcard.
’T’ can be entered, as an option, after a
telephone number. When it is entered, the
system collects the dial digits until
end-of-dialing key (default#) or interdigit
timer is finished.
model name(config-dial-peer)#
-pattern