Specifications

VoiceFinder VoIP Gateway Configuration Guide (APOS 2.0) Release Version 3.1
AddPac Technology Co., LTD
- 144 / 416-
The following Figure 3.4 shows how end-to-end call, between Dial Peer 1 and Dial Peer 4, is
completed.
Figure 3.4 Outgoing Call from a View Point of POTS Dial Peer 2
Please use the following commands to complete end-to-end call, between Dial Peer 1 and Dial
Peer 4 in the configuration of Figure 3.4:
dial-peer voice 4 pots
destination-pattern 1310555 . . . .
port 0
dial-peer voice 3 voip
destination-pattern 1408555 . . . .
Session target 10.1.2.2
As it is described above, call completion in the gateway can be accomplished basically by
selection of inbound and outbound dial peers.
Selection of outbound dial peer is determined by pattern matching between dialed digits and
destination patterns of POTS peer and VoIP peer.
Selection of inbound dial peer is determined by following rules different from POTS peer and
Vo I P p e e r.
The followings are the selection procedure of inbound POTS peer:
z Choose POTS peer specified with voice port and the call has been received.
Voice Port
IP Cloud
Source
Destination
[phone]
Dial Peer 2
POTS Call leg
VoIP Call leg
PBX
PBX
[phone]
10.1.1.2
10.1.2.2
Voice Port
Dial Peer 1
Dial Peer 3
Dial Peer 4