Specifications

VoiceFinder VoIP Gateway Configuration Guide (APOS 2.0) Release Version 3.1
AddPac Technology Co., LTD
- 114 / 416-
1. Version {3|4}
y Specify NTP server version information. When it is not specified, it is operated by 4.
The version 4 is used in general.
2. retry <2-120>
y This is the time interval for retry incase performing NTP fails. Without setup, the
retry time interval is set to 10 minutes.
3. resynchronize <0-72>
y This is the retry time interval when NTP is successfully performed. Without the
setting, the retry is not performed.
z radius-server host { A.B.C.D|ALIAS }
Specify the server address for RADIUS server configuration. Only one server is supported
and all the IP and DNS address formats are possible.
z radius -server key WORD
1. Enter an encryption key for the server authentication for RADIUS server configuration.
2. The encryption is one string and no space or ‘?’ between the characters are allowed.
z radius -server retransmit <0-100>
1. Set a counter of retransmission for RADIUS server configuration.
2. Specify the maximum number of retransmission when there is no response for the
message has been sent for a certain timeout period.
3. Without the setting, basically it repeats 3 times.
z radius -server timeout <1-60>
1. Set the server timeout for RADIUS server configuration.
2. Without the setting, basically it is set to 3 seconds.
z radius -server accounting { telephony|voip} {start|stop}
1. Set the information related to RADIUS Accounting.
2. ‘telephony’ means the section for the interfaces of FXO/FXS/E&M/E1/T1 and ‘voip’
means the section for VoIP.
3. ‘start’ means the start of the call, ‘stop’ means the termination of the call.
4. When this is not configured, RADIUS Accounting information is not transmitted.