Installation guide

VoiceFinder AP100 VoIP Gateway Installation Guide (Edition 1.0)
AddPac Technology Proprietary & Documentation 40 - 39
4.2. Cable Specification
This section describes the pinout specification of the following cable used for AP100:
z Pinout of Ethernet cable assembly (RJ-45 to RJ-45)
[ Pinout of Ethernet Cable Assembly (RJ-45 to RJ-45) ]
An RJ-45 to RJ-45 Ethernet cable is used to connect AP100 to another device (typically hub). The pin
sequence of the RJ-45 connector is shown in Figure C-1. For the signals and pinout specification,
refer to Table C-2, “Signals and Pinout of Serial Ethernet Cable”.
[Figure 4-1] 100 Base-T RJ-45 Connector
RJ-45 Signal Direction RJ-45 Pin
1
Tx + →
1
2
Tx - →
2
3
Rx + ←
3
4
- -
4
5
- -
5
6
Rx - ←
6
7
- -
7
8
- -
8
[Table 4-1] Signals and Pinout of Direct Ethernet Cable
1. This specification is about the serial cable that connects AP100 to the hub.
2. Use a cross cable to inter-connect AP100s or to connect AP100 to the PC.