User`s guide

VoiceFinder AP200 VoIP Residential Gateway (RGW) User’s Guide Version 1.1
AddPac Technology Co.,Ltd. -
58 -
z ppp chap password password
This command is for PPP client devices. This command registers a password
to request connection to the PPP server device when using PPP CHAP
authentication. (An optional command for CHAP authentication).
z ppp pap sent-username username password password
Sets PAP authentication in the PPP client device. When the client device
sets a PPP call, the client device sends the user name and the password to
the server for authentication. At this time, the user name and the password
shall be the same with those set in the server. (An optional command for
PAP authentication)
z ppp peer default-ip-address <ip-address>
1. Sets the router as a PPP server and the IP address to allocate to the serial
interface of the other side. (An optional command)
2. When the router receives the IP address, the router decides the subnet
mask of the IP address that it received based on the IP subnet that has
been set in its local interface.
z ppp timeout <second>
1. Sets PPP negotiation timeout for PPP negotiation between two gateway.
(An optional command)
2. The default is five seconds.
z shutdown / no shutdown
An optional command to make the current interface up/down.
z show interface <if-name>
Shows the interface status of “if-name.”
z show modem
Shows the modem control status of async 0 interface
Using this command, a user check the configuration of async 0 interface.