User`s guide

VoiceFinder AP200 VoIP Residential Gateway (RGW) User’s Guide Version 1.1

AddPac Technology Co.,Ltd. -

56 -

[Procedure]

Step Operation

1 Enter into the interface configuration mode.

2 Give PPP encapsulation protocol to the interface.

3 Move to the IP configuration mode.

4 Give an IP address to the interface.

5 Enable CHAP or PAP authentication. (Optional)

6 Set CHAP or PAP parameters. (Optional)

7 Set PPP default peer IP. (Optional)

(If necessary) use “debug” command to check if AP160 dial-up VoIP

gateway is normally operating.

9 Make the interface up.

With “show interface” command, check if the interface is normally

operating.

(For abnormal operation) find faults and recover faults as using

“debug” command.

[Related Commands and Syntax]

z interface { async/ ethernet } { 0 / 1 }

Selects the interface to set up and enters into the interface configuration

mode.

z modem dialing|do-script|keep-active|shell|speed} {…}

Enters into the async interface configuration mode

For a detailed command usage, please refer chapter “4.2.3.2.2 Modem

commands”

z encapsulation { ethernet / ieee / vlan / ppp }

Selects the modem encapsulation mode among above listed encapsulation

mode