User`s guide

VoiceFinder AP200 VoIP Residential Gateway (RGW) User’s Guide Version 1.1

AddPac Technology Co.,Ltd. -

34 -

DSP S/W download (0): .. OK

The System is ready. Please login to system.

Interface async0, changed state to UP

Interface ethernet0.0, changed state to UP

VoipGateway::Init1 - No IP address on the VoIP Interface

[Fig. 3.3 VoiceFinder AP160 Initial Screen]

3.2. Environment Configuration

The Gateway requires various configurations of parameters according to the

application. This section provides important information for using the Gateway

and the user is highly advised to follow the following procedures before

configuring the Gateway.

z Clarify the network address according to the IP with the network diagram.

z Determine which routing protocol to use. (e.g. Static, Default etc.) In doing

so, discussion with the administrator of the connecting network is required.

z Determine the protocol to use with each LAN 1(WAN) port. (e.g. PPPoE,

Ethernet etc.)

z When the conditions above are determined, thoroughly understand the

related commands

Environment configuration is required only once at initial installation. But when

the network components have changed, settings must be reconfigured. At

completion of configuration, users always save the settings to prevent loss of

data when switching the power on or off.

Information