User`s guide

VoiceFinder AP200 VoIP Residential Gateway (RGW) User’s Guide Version 1.1
AddPac Technology Co.,Ltd. -
30 -
Gateways or PCs connected to the Gateway.
z Check the routing table to confirm if the Gateway is receiving the network
information correctly.
z Use the Ping command to check other gateways or PCs connection.
z This completes the basic configuration procedure. For optional functions,
refer to the related chapter
3.1.2. Console Connection
z Connect the console port in the rear side of the Gateway with the serial
port of the prepared console terminal. (Refer to [Diagram 3.1 Console
Cable Connection])
9 Use console cable provided in the package.
9 If using a PC for the console terminal, connect with the PC serial
port.
z In order to use the PC as a console terminal, a communication emulator
application is required. Under normal circumstances, the Hyper Terminal
Program in Windows will suffice.
z The console terminal should be configured as : 9,600 Baud, No Parity, 8Bits
Data, One(1) Stop Bit. The VoiceFinder AP200 Gateway is set to operate
with the configurations above. Therefore, these settings are required for
communication between the Gateway and the console terminal. (Refer to
[Diagram 3-2 Hyper Terminal Configuration])
z When configuring the Hyper Terminal, select the Hyper Terminal menus in
the following order: File Æ Configuration Æ Connection Target Æ Format
and set each item.
z The console port serves the purpose of configuring the VoiceFinder AP160
Gateway settings and checking its operating status.