User`s guide

VoiceFinder AP200 VoIP Residential Gateway (RGW) User’s Guide Version 1.1
AddPac Technology Co.,Ltd. -
18 -
Following figure shows the standard configuration of the back side panel of
AP160 dial-up VoIP gateway.
[Figure 1-5 Back side panel diagram of VoiceFinder AP160 dial-up VoIP
gateway]
Following Table 1-2 explains the back side panel interface of AP160 dial-up
VoIP gateway.
No. Interface Explanation
(1)
DC power
External DC power supply input (5V)
(2)
PSTN
This port is used to connect PSTN subscriber line for
VoIP service via dial-up modem or PSTN backup
(RJ11)
(3)
FXS
1 FXS Port : As a FXS voice interface port, analog
phone or FAX machine can be connected (RJ11)
(4)
UP-LAN-NORMAL
10 Mbps Ethernet interface for WAN or LAN
connection. UP port is used for uplink or direct
connection with PC LAN port. NORMAL port can be
used for LAN port connection via HUB equipment.
UP and NORMAL ports are not two LAN port.
Therefore user should select one(1) LAN port type
among UP and NORMAL LAN ports.
(RJ45)
(6)
Console
RS-232C port for system management (RJ45)
[Table 1-2 The explanation of back side panel Interfaces of AP160 dial-up VoIP
gateway]