User`s guide

VoiceFinder AP200 VoIP Residential Gateway (RGW) User’s Guide Version 1.1
AddPac Technology Co.,Ltd. -
17 -
[Figure 1-4 The front panel diagram of VoiceFinder AP160 dial-up VoIP
gateway]
Table 1-1 shows the functional explanation about each LED of VoiceFinder
AP160 dial-up VoIP gateway.
No. Interface Explanation
(1)
POWER
Power LED, display whether external power is supplied normally or
not. (Green)
(2) FXS Display the operation status of “FXS” voice interface port.( Yellow)
(3) PSTN Display the operation status of PSTN backup port (Red )
(4) MLINK Display the LINK status of PSTN modem interface (Green)
(5) MACK
Display the activity status such as transmission and receive packet
of PSTN modem interface. (
Yellow )
(6) LNK Display the LINK status of Ethernet interface.(Green)
(7) TX Display the transmission activity of Ethernet interface.(Yellow)
(8) RX Display the transmission activity of Ethernet interface.(Yellow)
[Table 1-1. The explanation of front panel LEDs of AP160 dial-up VoIP gateway]
Rear View of AP160
In rear side of AP160 dial-up VoIP gateway, this equipment provides the PSTN
modem interface(including PSTN backup interface), one(1) 10Mbps Ethernet
interfaces, RS-232C serial port for management, and FXS interface port for
voice signal processing. An Ethernet port is used for VoIP service via WAN side
such as xDSL, cable modem interface. Also this Ethernet port can be used for
external modem application via LAN port of Personal Computer.
Standard Configuration Model