User`s guide

PassFinder AP2520 VoIP Router/Gateway Operation Manual Version 1.10 / Mar. 2002
AddPac Technology Co., Ltd. -
80 -
[Procedure]
Setting the PassFinder AP2520 router as a frame-relay access router (with PVC)
Step Operation
1 Enter into the interface configuration mode.
2 Give frame-relay encapsulation protocol to the interface.
* Configuration of the main interface
3 Move to the IP configuration mode.
4 Give an IP address to the interface.
5 Set the static or the dynamic map.
6 Set the counter and the timer for the LMI. (Optional)
7 Set other necessary parameters.
8 Make the (main) interface up.
* Configuration of the sub-interface
1 Create a sub-interface and enter into the corresponding configuration
mode.
2 Move to the IP configuration mode.
3 Give an IP address to the interface.
4 Set the static or dynamic map.
5 Set the counter and the timer for the LMI. (Optional)
6 Set other necessary parameters.
7 Make the (main) interface up.
* Common
1
With “show running-config” command, check if configuration has been
accurately made.
2
With “show interface” command, check if the interface is normally
operating.
3
(In case of a fault) use “debug” command to find and recover faults in the
network connection.