User`s guide

PassFinder AP2520 VoIP Router/Gateway Operation Manual Version 1.10 / Mar. 2002
AddPac Technology Co., Ltd. -
53 -
4.4. Ethernet Configuration
4.4.1. Ethernet basic configuration
The Ethernet port of the PassFinderAP2520 Gateway basically supports RJ-45.
However, if the connection device of the other side supports only the AUI port, 10
Base-T Medial Attach Unit (MAU) shall be used in the other side. The Ethernet of
the PassFinderAP2520 Gateway uses the standard ARPA encapsulation method
as the default. However, if necessary, the network manager can use SNAP or
IEEE 802.3 encapsulation method.
The logical port can separate the Ethernet of the PassFinderAP2520 Gateway. If
the user wishes to use only one Ethernet port, the user must designate the logical
port.
Do the following to use the Ethernet.
[Procedure]
Step Operation
1 Enter into the interface configuration mode.
2 Enter into the IP configuration mode.
3 Give IP address to the interface.
4 Designate the encapsulation method to use (if necessary.)
5 Make the interface up.
6 Set other necessary optional parameters.
[Related Commands and Syntax]
z Ethernet full-duplex
1. Sets the operation mode of the Ethernet interface.
2. The default is half-duplex.
z interface { Ethernet /Serial} { 0 / 1 }.[logical I/F #]
1. Selects the interface to set up and enters into the interface