User`s guide

PassFinder AP2520 VoIP Router/Gateway Operation Manual Version 1.10 / Mar. 2002
AddPac Technology Co., Ltd. -
35 -
3.2. Environment Configuration
The Gateway requires various configurations of parameters according to the
application. This section provides important information for using the Gateway
and the user is highly advised to follow the following procedures before
configuring the Gateway.
z Clarify the network address according to the IP with the network diagram..
z Determine which routing protocol to use. (e.g. Static, Default, RIP, OSPF
etc.) In doing so, discussion with the administrator of the connecting
network is required.
z Determine the protocol to use with each WAN(Serial) port for router model.
(e.g. HDLC, PPP, Frame-Relay, etc.)
z Determine the protocol to use with each LAN 1(WAN) port for gateway
model. (e.g. PPPoE, Ethernet etc.)
z When the conditions above are determined, thoroughly understand the
related commands.
Environment configuration is required only once at initial installation. But when
the network components have changed, settings must be reconfigured. At
completion of configuration, always save the settings to prevent loss of data
when switching the power on/off.
In order to log in at an unconfigured Gateway, the user must use a set
username and password. The user access authority for PassFinder AP2520 is
divided into 4 levels : admin, high, normal, low. All users, other then Admin is
prompted “1router>” at log-in.
The user must log-in at admin level for Gateway configuration. Factory settings
for admin level log-in uses “root” for username and “router” for password. The
Information