User`s guide

PassFinder AP2520 VoIP Router/Gateway Operation Manual Version 1.10 / Mar. 2002
AddPac Technology Co., Ltd. -
333 -
router(config)#
router(config)# dial-peer voice 0 pots
router(config-dialpeer-pots-0)# destination-pattern 100
router(config-dialpeer-pots-0)# port 0/0
In case of above example, if calling number “1001234” is received from network
side, number “1234” is transmitted to peer side via ISDN PRI or R2 signaling
interface.
z If a user does not want to register the E.164 number of peer side in gatekeeper, use the
following command.
router(config-dialpeer-pots-0)# no register e164
5.8.7. VoIP Outgoing Call Scenario
z At first, a PBX internal-line user presses the prefix KEY number (example, 9,etc) after off-hook.
After prefix KEY input, PRI line is hunted, if digit input method is overlap, a user can hear the
dial-tone from VoIP gateway. After hearing the dial-tone, a user presses the called party number.
If PBX digit input method is enbloc mode, END OF DIGIT # key must be pressed after dialing. In
case of overlap mode, END OF DIGIT # key input is optional.
z AddPac VoIP gateway performs the H.323 outgoing call procedure according to dial-plan using
called party address number received from PBX signaling interface. In this time, calling party
address is internal-line number received from PBX signaling interface as a default mode. If a
user want to change the calling party number, number translation of voice port or voice peer is
necessary. As an example, if a user want that calling party number of all outgoing call is
translated as “ 2002000” number, it will be solved by following command procedures.
router(config)# translation-rule 0
router(config-translation-rule#0)# rule 0 . 2002000%88
router(config-translation-rule#0)# exit
router(config)# dial-peer voice 1000 voip
router(config-dialpeer-voip-1000)# translate-outgoing calling-number 0
5.8.8. VoIP Incoming Call Scenario
z VoIP incoming call uses the enbloc digit transmission method. If destination pattern of dial-peer