User`s guide

PassFinder AP2520 VoIP Router/Gateway Operation Manual Version 1.10 / Mar. 2002
AddPac Technology Co., Ltd. -
330 -
Pinouts for T1/E1 Trunk
and Digital Voice Port
(RJ-45) Pin
Signal
1 RX (tip)
2 RX (ring)
3 -
4 TX (tip)
5 TX (ring)
6 -
7 -
8 -
5.8.4. Voice Port Configuration of APVI-1E1 Interface Module
(Optional)
z If APVI-1E1 is installed on slot0 of AP2520 VoIP equipment, voice port is 0/0. If APVI-1E1 is
installed on slot1 of AP2520 VoIP equipment, voice port is 1/0.
z The VoIP configuration setting of E1 voice port is same with analog FXS/FXO configuration
setting procedures. Following example show the input gain setting procedures of APVI-E1 VoIP
digital E1 interface module installed on slot0. In this example, -3 means the 3dB gain.
router# config
Enter configuration commands, one per line. End with CNTL/Z
router(config)# voice-port 0/0
router(config-voice-ports-0/0)# input gain –3