User`s guide

PassFinder AP2520 VoIP Router/Gateway Operation Manual Version 1.10 / Mar. 2002
AddPac Technology Co., Ltd. -
30 -
commands.)
z Save the settings on Flash Memory. (PassFinder AP2520 immediately
operates under the new settings, but under certain network environments
rebooting is required.) (Refer to the following instructions for this part.)
z Using commands such as Ping, Telnet, rlogin etc. check the status of other
Gateways or PCs connected to the Gateway.
z Check the routing table to confirm if the Gateway is receiving the network
information correctly.
z Use the Ping command to check other Gateways or PCs connection.
z This completes the basic configuration procedure. For optional functions,
refer to the related chapter
3.1.2. Console Connection
z Connect the console port in the rear side of the Gateway with the
serial port of the prepared console terminal. (Refer to [Diagram 3.1
Console Cable Connection])
9 Use console cable provided in the package.
9 If using a PC for the console terminal, connect with the PC serial
port.
z In order to use the PC as a console terminal, a communication
emulator application is required. Under normal circumstances, the
Hyper Terminal Program in Windows will suffice.
The console terminal should be configured as : 9,600 Baud, No Parity,
8Bits Data, One(1) Stop Bit. The PassFinder AP2520 is set to operate with
the configurations above. Therefore, these settings are required for
communication between the ptoduct and the console terminal. (Refer
Caution