User`s guide

PassFinder AP2520 VoIP Router/Gateway Operation Manual Version 1.10 / Mar. 2002
AddPac Technology Co., Ltd. -
255 -
Configuring this command for an E&M voice port changes only the signal value
for the selected voice port.
Some PBXs will miss initial digits if the E&M voice port is configured for
Immediate signaling. If this occurs, use Delay-Dial signaling instead. Some
devices have a limited number of DTMF receivers. This type of equipment must
delay the calling side until a DTMF receiver is available.
5.7.3.11.5. Examples
In the following example, as soon as the line is seized by the off-hook state of
the E-lead for the corresponding E&M voice port, DTMF numeric data is sent.
voice-port 1/1
signal immediate
5.7.3.12. timing delay-duration (E&M Voice Port Command)
To specify the delay signal duration for a specified voice port, use the timing
delay-duration command in voice-port configuration mode. To reset the
default value, use the no form of this command.
timing delay-duration milliseconds
no timing delay-duration
5.7.3.12.1. Syntax Description
Keyword / Argument Description
milliseconds
Delay signal duration for delay dial signaling, in
milliseconds. Valid entries are numbers from 100 to
5000. Supported on E&M ports only.
5.7.3.12.2. Default
200 milliseconds