User`s guide

PassFinder AP2520 VoIP Router/Gateway Operation Manual Version 1.10 / Mar. 2002

AddPac Technology Co., Ltd. -

125 -

[Procedure-DHCP Server]

Step Operation

1 Move to the configuration mode.

2 Define the DHCP-list type to use in the Gateway.

Create a DHCP-list defining DHCP-list number, DHCP mode to use in

the Gateway, or DHCP address pool.

9 If the server type is DHCP, set a DHCP pool that defines the

DHCP start-address and the DHCP end-address.

9 If the server type is DHCP, set a DHCP pool that defines the

DHCP start-address and the DHCP end-address.

4 Set other DHCPs and other necessary options.

5 Go to the interface configuration mode.

6 Enter into the IP configuration mode.

7 Apply the DHCP-list that has been set to the corresponding interface.

8 Use “Show dhcp-list” to check if desired DHCP has been correctly set.

[Procedure – DHCP Client ]

순서 작업 내용 Description

1 Move to the configuration mode.

2 Select the interface configure as a DHCP Client

Apply the DHCP-Client instead of IP Address to the corresponding

interface

[Related Commands and Syntax]

Mandatory Commands

z dhcp-list <dhcp-list-number> type {server/relay}

Creates the DHCP list of the Gateway (dhcp-list-number: any number

between 0 and 4) and sets DHCP in the list should function as a server or

protocol relay.