User`s guide

PassFinder AP2520 VoIP Router/Gateway Operation Manual Version 1.10 / Mar. 2002
AddPac Technology Co., Ltd. -
102 -
z ospf dead-interval <interval-time>
1. Sets information of the router after a neighboring router declares dead.
2. The default is four times of the hello-interval.
z ospf poll-interval <interval-time>
1. Sets the interval for the polling packet.
2. The default is same with the hello-interval.
z ospf retransmit-interval <interval-time>
1. Sets retransmission interval when the router loses link state
advertisement value.
2. The default is same with the hello-interval.
z ospf default-router
1. Notifies that the router is the default router to the OSPF network.
2. Same command as “default-information originate” of other routers.
3. This command can be executed only when the router is an ABR.
z ospf neighbor <neighbor_ip_address>
1. Statically sets the neighbor.
2. Used for the HUB interface of the frame-relay network that is one of
representative Non-Broadcasting Multiple Access (NBMA) networks.
z ospf network { broadcast / non-broadcast / point-to-multipoint }
1. Defines interface characteristics in OSPF.
2. Can be used only in the serial interface.
3. Statically sets the neighbor.
z show route
Checks the routes in the routing table.
z show router
Checks the enabled routing process.
z show ospf {area / config / debug / interface / lsdb / nbma-nbr / neighbor /